is this a good first layer? - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

hi. i just got done with a 47hr print which has a similar 1st layer to the one i'm showing here. the previous model was pretty stringy, the 1st layer is somewhat uneven feeling on the bottom, but other than that it's printed fairly well for 47hrs! so this is another component of the 47hr print, t

First layer problems, again - Improve your 3D prints - UltiMaker

Best 3D printers for 2024

Ultimaker Go first layer print problem - Improve your 3D prints

First layer line gap - UltiMaker Cura - UltiMaker Community of 3D

is this a good first layer? - Improve your 3D prints - UltiMaker

The New UltiMaker S3

Why no internal supports on first layer? - UltiMaker Cura

is this a good first layer? - Improve your 3D prints - UltiMaker

Kevin's Take: The Best 3D Printer for Hobbyists - Product Design

3D printing: What you need to know to get started

Cura Settings Decoded – An Ultimaker Cura Tutorial

The Best 3D Printers in 2024 – Buyer's Guide

Supports first layer is not right - UltiMaker Cura - UltiMaker

First layer woes - Improve your 3D prints - UltiMaker Community of

Print detailed objects faster using adaptive layers in Ultimaker