P1p first layer is no longer as good as before - Troubleshooting - Bambu Lab Community Forum

$ 15.50

4.7
(203)
In stock
Description

Hey guys so since I did the last update to be at the latest firmware my first layer is lost it’s textured finish. I tried reverting to the previous firmware and still same issue. Support asked to to check the belt tension, recalibrate and manual level. Now I’m found calibration on the K value but the one value that looks best has problems with adhesion and one corner will lift lol, if I change it back to default it will print with no lift lol. Any other ideas from the group as to what I should t

Bambu Lab P1P P1S X1C X1E Spring Steel Build Plate With Configurable Top garolite, G10, Carbon Fiber

Releases · bambulab/BambuStudio

Has anyone had direct experience use JB Weld on metal to PLA

P1P randomly stopped working well (SOLVED) - Troubleshooting - Bambu Lab Community Forum

Problem with first layer inspection - Bambu Lab X1 Series - Bambu Lab Community Forum

Bambu Lab X1 Carbon Review (With AMS) - 3DGearZone

Problem with First layer with all filaments . Bambulab filament included . : r/BambuLab

Bambu Lab P1P 3D Printer

Very frustrating issues with first layer adhesion when printing towards edge of build volume with all filaments. Bed cleaned with soap and warm water. Manually leveled bed (per their guide). Slowed down

Bambu Lab A1 Review: Full Size Bed Slinger

Has anyone had direct experience use JB Weld on metal to PLA

New p1p first layer issues. : r/BambuLab