is this a good first layer? - Improve your 3D prints - UltiMaker

hi. i just got done with a 47hr print which has a similar 1st layer to the one i'm showing here. the previous model was pretty stringy, the 1st layer is somewhat uneven feeling on the bottom, but other than that it's printed fairly well for 47hrs! so this is another component of the 47hr print, t

Mastering the First Layer: 5 Tips for Perfect 3D Prints - Smith3D Malaysia

How to Operate Ultimaker to Prepare a Print?

5 Common Cura Errors and How to Solve Them

AnkerMake Explore the 3D Printing Frontier - Ankermake Europe

Solutions for poor adhesion to the print bed

3D Printing 101: How to Succeed with a Perfect First Layer for Every 3D Print

Advice needed: tearing in first layer : r/3Dprinting

3 Ways to Improve Build Plate Adhesion (Rafts, Skirts, & Brims)

Improving the bottom layer - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

adhesion - What's the difference between Initial Layer Width and Initial Layer Flow in Cura? - 3D Printing Stack Exchange

Is there a way to make the first few layers of supports solid to help stop it from coming loose and falling over on tall prints? Neptune 3 Max and Cura

UltiMaker S5 3D Printer - Source Graphics