How do I cut out around the outline of an image? - Resources - LightBurn Software Forum

$ 12.99

4.6
(223)
In stock
Description

Imagine you have an image loaded that you’d like to engrave, then cut out: With the image selected, go to Tools > Trace Image (or press Alt+T): Adjust the threshold and other controls until you see the edge you want shown in purple: Click Ok to keep the trace, and make sure ‘Delete image after trace’ is not enabled since you want to keep the image for engraving. Now you’ll have a vector copy of the image sitting directly over the original. Turn off the ‘Show’ button on the image to make

How do I cut out around the outline of an image? - Resources

How do I cut out around the outline of an image? - Resources

How do I cut out around the outline of an image? - Resources

How do I cut out around the outline of an image? - Resources

How do I cut out around the outline of an image? - Resources

How do I cut out around the outline of an image? - Resources

How do I cut out around the outline of an image? - Resources